How to repair broken laptop power jack? - Free tips for- (Advance Level)

 

Are those who are using a laptop, and how much danger they are well aware of the problems of laptops. Laptop repair of an expensive process. In this article today I will tell you how you can bring a laptop broken power jack. The money you will save at least 000 / - to 500 / - to Rs (depending on the reputation of the service center).

The problem is that the laptop power jack shaky (Loose) go, broken, broken away, too hot, the Bar Disconnect going on. In this case, you will be sure that the issue of Jack.

Here is the original laptop power jack rather than iron jack (Radio Shack- Part No-274-1576) will be used (saija 5.5 mm x .5 mm). More details to produce the same type or a plastic jack is not possible for everyone. Electronics Parts purchase will go to stores to buy the jack and jack the price of this kind may be up to Rs 50 from Rs 0.

One thing to keep in mind here is that, you get Jack on the market can not meet fully with the charger port on your laptop. Jack, you have to buy the whole set. We'll set one with the laptop and the other charger will replace the head.

This procedure applies to any laptop, but I know you must be open to the skilled hands of the laptop. Activities, or the power to enforce any mistake can cause new problems.

(Source of courage to open the procedure is usually very close to a variety of laptop models)

This is the original way to make sure that my replacement panel-mount jack- Jack seek long use.

Take time to market with a laptop charger. And maybe with the charger port can milamato. In that case, the task will be somewhat easier for you.

Let then.

STEP 1

First, remove the jack and the jack from east fitting plastic support to smooth cut with a small knife or Paper cutter.

After harvest, the place will look like.

Step 2

Jack the external side of the cut, according to the size of your purchase to the jack. Make a little more carefully jyatati fit tightly.

Step 3

Jack the length of your purchase may be a little bigger in the upper part look at the laptops that do not get stuck. Jack scratch or cut some parts may require more top roles.

Step 4

Both positive and negative, from the beginning of the pre-existing jack cut disconnect.

So that the rubber insulation, cut off the head of his two copper wires come out. The red color of the tarati the positive (+) will be added to your purchase jack connector in the middle and black tarati negative (-), which is associated with the rest of the external jack. Stretch of the red (+) and black (-) cable instead of the laptop model, depending on the color green (+) and White (-) may have.

Step-5
Now Jack Laptop Press the Bolt to see the well-locked tightly likes it.

Step-6

Add to Jack purchased the cable connection. Red alert karachi again tarati the positive (+) will be added to your purchase jack connector in the middle and black tarati negative (-), which is associated with the rest of the external jack.

Take the good quality electrical tape around the connection that is not short. Now you choose carefully fold bending connection.

See if everything is just right.

Step-7

Congrats! Work !! The laptop and remove the part that fits properly seated and see what you've done !!!

See more......



Simple or complex matters more details about the computer I'm trying to write my site / blog http://www.expertbd24.com.  
Computers Expert technical cooperation can visit.